Clinch Standoffs

A cylindrical fastener with a low-profile, hexagon-shaped head. The end opposite the head is internally threaded. It is considered a "blind" fastener because the threaded section does not extend through the entire length of the standoff. Immediately below the head is a slight indentation that extends completely around the item's circumference. This indentation, or groove, provides the clinching action when the part is pressed through a properly-sized hole in sheet metal.

The standoff becomes permanently set when squeezed into place into a proper size drilled or punched hole. After it is pressed into place, the standoff forms a flush surface with the sheet metal.

Sort By:
Filters:
Diameter
Thread Pitch
Length
Material
Page {pageNumber} of {pagesNumber}

No items match your selected filters. Please change or reset your filters to try again.

Page {pageNumber} of {pagesNumber}
Loading
Item Added to Cart
 View Cart
Favorites Updated
View Favorites
This website uses cookies to ensure you get the best user experience. By continuing to use this site, you agree to our Terms & Conditions.